Table of Contents(Page UD-69)

Ultra-DekŪ DESIGN

TRIM DETAILS
SNOW GUTTER


HIGH SYSTEM

LOW SYSTEM

NOTES

  1. Attach gutter to eave plate with Fastener #14A (3 fasteners per 10 piece).
  2. Install gutter straps 3'-0" o.c.
  3. Apply Tri-Bead tape sealer to slope leg of gutter.
  4. Use minor rib tape sealer to fill voids in panel at minor ribs as shown on page UD-34.
  5. Install panel with Fastener #1 E at prepunched holes. Panel must not overhang into gutter.
  6. Front top edge of gutter must not project above the plane of the panel pan.

Back   Next