Ultra-DekŪ DESIGN
FLOATING PEAK BOX INSTALLATION
- Install rake trim on each side of ridge to within 2" of centerline
of building.
- Install ridge flash so that it is on top leg of rake trim, 1" back
from outside edge.
- Temporarily set peak box in place and mark perimeter of box on rake trim
and ridge flash. Remove peak box.
- Just inside mark, install tape sealer continuously across ridge flash,
then down the face of rake trim on both sides of ridge.
- Place flexible membrane over tape sealer and hold in place with cinch
angles. Cinch angles should be attached with Fastener #4. To prevent leaks,
flexible membrane should be tight against ridge flash and rake trim with no
wrinkles at the sealed edges.
- Hook top of peak box over cinch angles installed on top of ridge flash and
attach bottom of peak box to endwall with Fastener #4.
Back Next
