Table of Contents(Page UD-44)

Ultra-Dek® ERECTION SEQUENCE
Step 12

SUBSEQUENT RUNS RIDGE/OUTSIDE CLOSURE NOTE Always stay one panel run behind with the outside closures, otherwise, the next panel cannot be installed. Install back-up plate and panel clips. Go to the previously installed ridge panel and peel protective paper from tape sealer. Apply tape sealer to the ridge panel just installed. Be sure to seal to the mastic on the previous panel. Install the outside closure in previous ridge panel. Rotate outside closure into position contacting the female side of the panel first. Using an awl, align the first hole on the female side of the outside closure with the corresponding hole in the panel and back-up plate. Remove the awl and install Fastener #1 E in the hole. Push the other end of the outside closure into position and align the holes with the awl. Remove the awl and install Fastener #1 E in all remaining holes except for the hole at the panel seam. Do not install the panel seam fastener at this time. Check panel alignment at this time (See page UD-48). Continue installing the roof until all but the last panel run has been installed. Panel module should be checked every third or fourth run.