Table of Contents(Page UD-40)

Ultra-Dek® ERECTION SEQUENCE
Step 8A

OPTIONAL ENDLAP- CINCH STRAP* NOTE • Step 8A applies only where more than one panel is used in a single slope. • All cinch straps on first panel run will require field modification. Remove awl and insert in the hole nearest the male leg. All holes in the upper and lower panels and the back-up plate should now be aligned with each other. Remove awl and place a cinch strap over the endlap. Replace awl in hole nearest male side of panel and, with Fastener #2B, install in proper sequence. Four fasteners are required at this time. The remaining fastener will be installed after the cinch strap for the next panel is applied To ensure that the male legs do not separate at the panel endlap, clamp the horizontal ledge with a vise grip C-clamp. This will allow room for the lower panel of the next run to be installed without removing the clamp. Apply Tri-Bead tape sealer over the notched portion of these male legs. Install a back-up plate and tape sealer on the upper end of the panel as in Step 5 and install clips as in Step 6. Repeat the endlap procedures as required for each panel until the ridge or high eave is reached. *Protected by U.S. Patent No. 4,655,020