Table of Contents(Page UD-38)

Ultra-DekŪ ERECTION SEQUENCE
Step 7

ENDLAP-PANEL

NOTE

Step 7 applies only where more than one panel is used in a single slope.

Position female lip of upper panel over support, while holding male side of panel up away from the tape sealer. Using an awl, align the hole nearest the female side of the top panel with the corresponding hole in the lower panel and the back-up plate.

Once this is accomplished, rotate the male side of the upper panel down to nest with the lower panel.

CAUTION

The roof should be swept clean of any drill shavings at the end of each day to prevent rust.

Back   Next