Table of Contents(Page UD-29)

Ultra-Dek® ERECTION SEQUENCE
Step 2

WALL PANEL INSTALLED BEFORE ROOF WALL PANEL INSTALLED AFTER ROOF

LOW SYSTEM EAVE For applications in which the wall panels have already been erected, install box panel cap trim to the eave strut with Fastener #14. Trim must be pulled tight to wall panels before fastening to eave strut. For applications in which the wall panels have not been erected, use offset panel cap trim. Use two fasteners per 10 piece or 3 fasteners per 20 piece. For low systems, lay Tri-bead tape sealer on top of the panel cap trim (box or offset). For high systems, do not install the Tri-Bead tape sealer at this point. Install double-faced tape along the length of the top leg of the panel cap trim (box or offset). Double faced tape must be upslope from Tri-Bead tape sealer. Lap box or offset panel cap trim 3’. Apply two beads of urethane sealant between the trim pieces, approximately from the end of the bottom piece.