Light Transmitting Panel, UL 90 - Ultra-Dek® (24" & 18" wide) Uninsulated - With Stiffener Plate and 10 Fasteners

10'-3" LONG
Reinforced
Reinforced/UV Resistant

Light Transmitting Panel, UL 90 - UItra-Dek® (24" & 18" wide) Insulated - With Stiffener Plate and 10 Fasteners

10'-3" LONG
Reinforced
Reinforced/UV Resistant

Light Transmitting Panel, Standard - Ultra-Dek® (24" & 18" wide) Uninsulated

10’-3" LONG
Reinforced
Reinforced/UV Resistant

Light Transmitting Panel, Standard - Ultra-Dek® (24" & 18" wide) Insulated

10'-3" LONG
Reinforced
Reinforced/UV Resistant

Tape Sealer

Tri-Bead	• Used at the eave plate, eave strut, outside closures, endlaps and trim connections	Tri- Bead 3/16" x 7/8" x 25' HW-504
Triple Bead	• Used at valleys and roof curbs	Triple Bead 3/16" x 2 7/8" X 20' HW-502

Tape Sealer - Minor Rib
• Used to fill void at minor
Pre-Cut Beveled ribs of the panel at the
7/32" x 1 3/8" x 4" eave
HW-512

Inside Closure

EPDM HW-428

• Metal or E.P.D.M. rubber • For use at the eave METAL HW-426

Double Faced Tape
• 1½x180 rolls Used to hold insulation in place at the rake and at any insulation end splices
HW-522

Thermal Spacer
• Polystyrene block used to increase the insulation capacity along the purlins

HW-575 (1)
HW-576 (5/8")
HW-577 (¾)

Shaping Tool
• If a problem is encountered in fully snapping the seams together, such as an incorrectly installed clip, damaged panel lip or a bubble caused by faulty assembly, the shaping tool should enable the seam to be locked with minimal effort
HW-600