PRODUCT INFORMATION COMMERCIAL

Table of Contents(Page CI-6)

COMMERCIAL/INDUSTRIAL PRODUCT INFORMATION

CONSTRUCTION
NO. 167
UL 90 LIGHT TRANSMITTING PANEL INSTALLATION

Install roof panels, leaving the light transmitting panel run open, except for lower light transmitting panel run panel. Install tape sealer to panel sidelaps and across panel width as normal.

Lay light transmitting panel in place overlapping lower metal panel 6". Do not install any fasteners at this time. Install tape sealer down light transmitting panel side laps. Apply double run of tape sealer across light transmitting panel width at lower and middle purlins. Tape sealer should align with beginning and ending edge of top flange of purlin. At the upslope end of light transmitting panel, apply double run of tape sealer for endlap.

Install 3" long pieces of "R" panel over light transmitting panel at the lower and middle purlins. Attach to purlins with six fasteners per piece of "R" panel. Fasteners must go between the two runs of tape sealer that were installed previously.

Back Next

	CONSTRUCTION NO. 167 UL 90 LIGHT TRANSMITTING PANEL INSTALLATION

	Install roof panels, leaving the light transmitting panel run open, except for lower light transmitting panel run panel. Install tape sealer to panel sidelaps and across panel width as normal.

	Lay light transmitting panel in place overlapping lower metal panel 6". Do not install any fasteners at this time. Install tape sealer down light transmitting panel side laps. Apply double run of tape sealer across light transmitting panel width at lower and middle purlins. Tape sealer should align with beginning and ending edge of top flange of purlin. At the upslope end of light transmitting panel, apply double run of tape sealer for endlap.

	Install 3" long pieces of "R" panel over light transmitting panel at the lower and middle purlins. Attach to purlins with six fasteners per piece of "R" panel. Fasteners must go between the two runs of tape sealer that were installed previously.