Table of Contents(Page CI-19)

COMMERCIAL/INDUSTRIAL PRODUCT INFORMATION

Panel Fastener Locations
(Panel Ends)

 

NOTE:
  1. "R", "M", "A", "C", "D" AND SUPRA RIB Panels have symmetrical side laps and may be lapped on either side. However, where possible, they should be lapped against the prevailing winds.

NOTE:

  1. The above are typical fastener spacings. However, they may not be appropriate for all applications. Consult a professional engineer for use on any specific application.
  2. Min. 1/2" x 3/32" tape sealer required at panel side laps when used as roof panels.
  3. Side lap fasteners are required. Typical spacing is 20" O.C. However, this spacing may not be appropriate for all applications. Consult a professional engineer for use on any specific application.

Back   Next