"PBR", "PBU", & S-36® PANEL PRODUCT INFORMATION

←Previous Page Next Page →
 Table of Contents

Page 27

TYPICAL DETAILS

Parapet Rake

Notes:

Beginning of Module
  1. Install 1/2" x 3/32" tape sealer to top of "PBR", "PBU" or S-36® panel rib.
  2. Install parapet rake trim to "PBR", "PBU" or S-36® panel rib with Fastener #4 (1/4"-14 x 7/8" Long Life Lap Teks) at 1'-0" on center.
  3. Attach top leg of parapet rake trim to 2" x 4" angle with Fastener #14 pop rivet. Elevate horizontal leg of parapet trim slightly, to provide for positive drainage of water.

  4. Trim laps should overlap approximately 3" with a bead of urethane sealant in between. Install a sufficient amount of Fastener #14 pop rivets to hold lap together.

    5.

Finishing off Module
  1. Cut and bend a 1" leg on "PBR", "PBU" or S-36® Panel.
  2. Install 1/2" x 3/32" tape sealer to top of "PBR", "PBU" or S-36® panel.
  3. Install parapet rake trim to "PBR", "PBU" or S-36® panel with Fastener #4 (1/4"-14 x 7/8" Long Life Lap Teks) at 6" on center.
  4. Attach top leg of parapet rake trim to 2" x 4" angle with pop rivets. Elevate horizontal leg of parapet trim slightly, to provide for positive drainage of water.

  5. Trim laps should overlap approximately 3" with a bead of urethane sealant in between. Install a sufficient amount of Fastener #14pop rivets to hold lap together.

    6.

Back   Next