"PBR", "PBU", & S-36® PANEL PRODUCT INFORMATION

←Previous Page Next Page →
 Table of Contents

Page 26

TYPICAL DETAILS

Parapet High Side Eave

 

Notes:
  1. Install outside closure, with 1/2" x 3/32" tape sealer top and bottom, across width of "PBR", "PBU" or S-36® panels.
  2. Install parapet high side trim to "PBR", "PBU" or S-36® panels at each major rib with Fastener #4 (1/4"-14 x 7/8" Long Life Lap Teks). Trim should overhang outside closures 1/2"-1".
  3. Attach top leg of parapet high side trim to wall with fasteners as required for wall substrate.

  4. Trim laps should overlap approximately 3" with a bead of urethane sealant in between. Install a sufficient amount of Fastener #14 pop rivets to hold lap together.

    5.

Back   Next