"PBR", "PBU", & S-36® PANEL PRODUCT INFORMATION

←Previous Page Next Page →
 Table of Contents

Page 25

TYPICAL DETAILS

Rake

Notes:

Beginning of Module
  1. Install 1/2" x 3/32" tape sealer to top of "PBR", "PBU" or S-36® panel rib.
  2. Install rake trim to "PBR", "PBU" or S-36® panel rib with Fastener #4 (1/4"-14 x 7/8" Long Life Lap Teks) at 1'-0" on center.
  3. Attach front face of rake trim to wall with fasteners or cleat as required for wall substrate.

  4. Trim laps should overlap approximately 3" with a bead of urethane sealant in between. Install a sufficient amount of Fastener #14 pop rivets to hold lap together.

    5.

Finishing off Module
  1. Cut and field bend a 1" leg on "PBR", "PBU" or S-36® Panel.
  2. Install 1/2" x 3/32" tape sealer to top of "PBR", "PBU" or S-36® panel.
  3. Install rake trim to "PBR", "PBU" or S-36® panel with Fastener #4 (1/4"-14 x 7/8" Long Life Lap Teks) at 6" on center.
  4. Attach front face of rake trim to wall with fasteners or cleat as required for wall substrate.

  5. Trim laps should overlap approximately 3" with a bead of urethane sealant in between. Install a sufficient amount of pop rivets to hold lap together.

    6.

Back   Next