"PBR", "PBU", & S-36® PANEL PRODUCT INFORMATION

←Previous Page Next Page →
 Table of Contents

Page 24

TYPICAL DETAILS

Eave Trim

Notes:
  1. Install eave trim to structure with three pop rivets per section.
  2. Install inside closures along top leg of eave trim with 1/2" x 3/32" tape sealer top and bottom.
  3. Install "PBR", "PBU" or S-36® panel with Fastener #3 (12-14 x 1 1/4" Long Life driller) on each side of major ribs (2 fasteners per foot) allowing panel to overhang 1 1/2" plus wall thickness. Fasteners must be installed up slope from inside closures.
  4. Attach front face of eave trim to wall with fasteners or cleat as required for wall substrate.

  5. Trim laps should overlap approximately 3" with a bead of urethane sealant in between. Install a sufficient amount of Fastener #14 pop rivets to hold lap together.

    6.

Back   Next