TYPICAL DETAILS

Hip

Notes:

1. Bevel cut and install "PBR", "PBU", or S-36^® panels to follow bevel of hip.
2. Install beveled outside closures to panels, with 1/2" x 3/32" tape sealer top and bottom, following bevel of hip. Beveled closures must be special ordered and require a two week lead time.
3. Install hip flashing to panel at each major rib with Fastener #4 (1/4"-14 x 7/8" Long Life Lap Tek). Hip flashing should overlap outside closures 1/2"-1"

4. Trim laps should overlap approximately 3" with a bead of urethane sealant in between. Install a sufficient amount of pop rivets to hold lap together.

Back   Next