TYPICAL DETAILS

High Side Eave

Notes:

1. Install outside closure, with 1/2" x 3/32" tape sealer top and bottom, across width of "PBR", "PBU" or S-36^® panels.
2. Install Sculptured High Side Eave to "PBR", "PBU", S-36^® panels at each major rib with Fastener #4 (1/4"-14 x 7/8" Long Life Lap Tek). Sculptured high side eave trim should overhang outside closures 1/2" - 1".
3. Attach front face of sculptured high side eave trim to wall with fasteners or cleat as required for wall substrate.

4. Trim laps should be approximately 3" with sufficient pop rivets to hold lap together. Apply bead of urethane sealant between trim at 3" lap.

Back   Next