ARCHITECT/ENGINEER INFORMATION

1. "PBR" panel is a structural roof and wall panel. This panel can be installed directly over purlins or joists. Several different UL 90 construction numbers are available for this panel.

2. "PBR" panel is recommended for 1/2:12 or greater roof slopes.

3. Field applied sealant is required at panel sidelaps and endlaps.

4. "PBR" panel is a through-fastened panel. For proper fastener application, see page 6.

5. The information in this manual is believed to be correct and accurate, It should not be used for any specific application without being reviewed by a registered professional engineer.

GENERAL DESCRIPTION

Coverage Width - 36"
Minimum Slope - 1/2:12
Panel Attachment - See page 6
Panel Substrate - Galvalume®
Gauge - 26 standard - 29, 24 and 22 also available
Coatings- Galvalume Plus®, Signature® 200* and Signature® 300*

PRODUCT SELECTION CHART

● - Available in any quantity.
■ - Minimum quantity may be required.
*See Commercial/Industrial color chart for available colors.

Back   Next