Table of Contents(Page DL-39)

Double-LokŪ ERECTION SEQUENCE
Step 8



FASTENER SEQUENCE
 FIRST RUN - ENDLAP

STANDARD ENDLAP

NOTE

Step 8 applies only where more than one panel is used in a single slope.

Remove awl and insert in the hole nearest the male leg. Install Fastener #1 E in the hole by the female leg. All holes in the upper and lower panels and the back up plate should now be aligned with each other.

Install Fastener #1 E in sequence 2, 3, 4 and the hole left by the awl after it is removed (5). Next, install Fastener #1 E in positions 6 and 7.

To ensure that the male legs do not separate at the panel endlap, clamp the horizontal ledge with a vise grip C-clamp until the endlap is fastened together. Apply Tri-Bead tape sealer over the notched portion of these male legs.

Repeat the endlap procedures as required for each panel until the ridge or high eave is reached.

Back   Next